![]() The commands to do this are #http server enable and #http 0 0 mgmt. Next, we need to enable http servers on the ASA to allow us to access it via the ASDM GUI. As you can see in my setup I’ve been given an IP address of 192.168.159.189. Wait a minute and then run the #show ip command. Go into configuration mode and configure the management interface as shown above. When you go into enable mode it will ask you for a password don’t panic as you just press enter and it will continue into enable mode this is the default behaviour of the ASA. Next, you need to configure the ASAv to get an IP address via DHCP and also activate the http server on the ASA and allow the IP that you get from DHCP to access the http server on the ASA. Connect the ASA Management 0/0 interface to the switch and then using another port on the switch connect it to the Cloud and select eth1 as the interface on the cloud, the eth1 interface should be bridged from VMware to your local machine. Drag your newly imported ASAv image onto the workspace along with the GNS3 Ethernet Switch and the Cloud object. bin file onto the ASA it is already on there even if you can’t see it when you do a dir, trust me it is!īelow is the topology I am using. I had a few issues getting the ASDM GUI working initially, note that you do NOT have to import the ASDM. A google search will get you the image you need. They also recommend that you use the ASAv directly from Cisco’s VIRL software. I would strongly recommend that you view that video. The GNS3 team have a great video showing you how to import the ASAv image into GNS3. Note if you want to run an ASAv image you must run it in GNS3VM and not in the GNS3 local.ĪSA image: asav952-204.qcow2 (VIRL image) After struggling to get the ASDM to work in GNS3 I thought it would be a good idea to write a blog post on how to get the ASA and ASDM working within GNS3.īelow is the ASAv image I am using and also the version of GNS3.
0 Comments
Leave a Reply. |